How to fix a gas stove

If any burners on your stove unevenly lit, or unlit, it is likely that its channels appeared blockages that need to be addressed. To check channels for obstructions, you must turn off all the taps of the gas supply. Then try to remove gently from the bottom of the fastening plate and lift them up. Below the hob must be a partition. Get her. Then you need to turn on the oven. Notice the burner flames. If it is the length of the burners will vary, it means that debris clogged up the individual channels. Turn off the oven. Wait for a while until the burner has cooled. After that, clean the channels with a thin needle.

Often fails element piezo-ignition. To fix this problem you need to turn off the stove. In the same way as in the first step, to remove the partition. Loosen the igniter and do a thorough inspection. If you find it cracked or various other defects, then replace it with a new one. Before making a replacement, make sure that the control module-ignition is disabled. Now we need to test the repaired plate.

If the door of the gas stove is jammed, or is it only, then you need to do the following. Not fully Unscrew the screws that attach the door directly to the plate. Try a little, wiggle it in different directions, so it is stronger sit down on the loop. Now you can re-tighten the bolts. Look tight now fits now the door to the stove. To check this, you can insert a plain sheet of paper between the gasket and the top edge of the plate. The gasket should tightly press the sheet.

If in the oven, you must replace the gasket to new one, proceed as follows. Turn off the gas, then slide from the wall plate. Gaskets need to Unscrew and then remove. Slightly Unscrew on the back panel bolts. Then, shaking gas stove, partially, move them from the body. Through these actions, the strip will detach from the liner and mounting of the housing. It remains only to put in a new gasket.