Instruction
1
Take a measuring Cup, a fork, a plastic container, and a form for molding, which fit a simple bowl. If you have purchased a set of casts, then you will find it in a bag of 3D gel. Pour into a bowl 100 g of powder and prepare 160 ml of warm water. The colder water for dilution of the gel, the slower it hardens.
2
Wait until the child is asleep, the procedure of removing the impression are not scared and not disturbed it, and pour in the powder prepared with water. Carefully stir the mixture with a fork until you get a smooth consistency without lumps. Take the bowl out over the edges and tap the bottom on a hard surface, table or chair.
3
This will allow to get rid of air bubbles in the solution. While the gel is not frozen, dip it in the palm of your hand child, and then the foot of his feet. After some time the gel needs to harden.
4
Curing time depends on how warm or cold was the water where you planted it. After curing carefully remove the gel molds with handles and legs baby.
5
In a small plastic container dissolve in water, gypsum powder and stir with a fork. The composition must acquire a consistency of liquid sour cream and not have lumps. In the silicone mold from the solidified gel gently pour the plaster solution.
6
Gently postukivanie the bottom of the molds on the table to expel the air bubbles. Pour, therefore, two forms, and then wait 30-40 minutes to complete solidification of gypsum. You can check the degree of hardening of gypsum – in the process of hardening the plaster is heated.
7
Flip the molds upside down and remove from your casts. In order to get a more clean look, sand the irregularities and roughness with fine emery paper and then Polish the pieces and dust with a cloth or brush.
8
The finished casts can be painted, glued on the glue to the base and place it in a frame.
