You will need
  • panel siding vinyl;
  • - crate;
  • - screws, nails;
  • - screwdriver;
  • - gon;
  • roulette;
  • - start and finish the placket;
  • - a wooden beam of cross section 50x100 mm Board thickness 50 mm;
  • - a sharp knife or box cutter-cutter with replaceable blades.
Instruction
1
Make a forest for the decoration of the pediment of the lumber section mm. 50x100 Flooring forest pitch out of the Board thickness of 50 mm, for braces take edged Board 25x100 mm. don't forget the fence. If the gable roof has a flow, connect the lower part of the forest is tightly to the wall. Use the stairs to finish the gable siding. Located high in the ridge take the second tier of the forest. Secure scaffolding for greater resistance to gable roof through the window.
2
Attach the vinyl siding one of 3 ways. First, fabricate the aluminum frame, and then install it panel siding. However, this costly method is not expensive. You can mount the panel directly on the wooden Gables of the roof. The best solution is to mount the siding on a wooden crate.
3
Attach the upright solid wooden blocks of the chosen cross-section across the gable at a distance of 40-50 cm from each other. Ensure the presence of the outer surfaces of the bars of the crates in the same plane. Wooden blocks fasten to the gable with nails, they are much cheaper than screws. But the panel of the siding to the sheathing attach with screws using a screwdriver. However, they almost zakruchivanie to the end, leaving the panel room for maneuver at high temperatures.
Siding installation
4
Start sheathing the gable siding. Using a level, install horizontally starting bar. Using screws attach it to each post. Groove starter plank align with the relevant ship. The distinctive click will show you on a correctly completed connection. It is called the castle. Installing the first row, then move on to the next row.
5
Cut the ends of the panels at an angle that follows the slope of the roof. Use the metal square. At a covering of the gable siding to leave a gap between the end of the panel and a crate. The clearance must be at least 1 cm are necessary to compensate for thermal expansion of the siding. And also it will prevent deformation of the panels, the shrinkage of the house.
6
Before laying the last row at the top, set finish bar. Border covering wall of the house and the gable, the interface panels hide under the plastic area. The decoration of the pediment is completed.