You will need
- Soft cloth (a thin suede microfiber cloth)
- Warm water
- Cleanser without fragrances
- Container
- Olive oil of high purity
Instruction
1
Place a piece of jewelry with pearlsω on the interval a clean, soft, lint-free cloth, for example, on a special microfiber cloth I use to clean monitors and optics. Fit and fine suede fabric. If your product is a necklace or pearl beads, unbutton the clasp and pull it out full length.
2
Prepare a container with warm water in which you need to pre-dissolve one or two drops of gentle detergent. Never use products with ammonia, soda, bleaching substances. Best solution ordinary baby soap without fragrance.
3
Immerse the product in soap solution for a few minutes. Immersion and extraction keep the earrings for the "loop" or "stud", rings, pendants and brooches for the metal parts, and necklaces and beads for the clasp.
4
Put the product back on the fabric, cover it and slightly Pat. Leave the pearl with a wet cloth and wait until it is completely dry. When the towel or cloth will be dry, a piece of jewelry is ready to further wear. Do not wear pearlswhile it dries. Wet pearls attract dirt, which then would be very difficult to remove.
5
If jewelry is left noticeable traces of dirt, repeat the procedure again, starting with soaking in warm soap solution. Never clean pearls using sponges or toothbrushes.
6
To return the pearlshave luster, it can be wiped with a cloth, to which were applied just one drop of olive oil of high purity.
7
The rule is to wipe your pearls with a soft cloth each time after you wore it, because sebum can gradually eat away at the nacre, to make the coating softer and more friable.