How to set universal remote control for air conditioning

As a rule, when lost or broken remote control to turn on the air conditioner impossible. To purchase a new remote for a specific model of air conditioner does not always work. Therefore, the purchase of a universal remote control is the only way out. With this remote you can control any air conditioning. For this you need to configure the remote for your model of air conditioner.

The principle setting of all remotes is the same and is in the water the desired code in the console memory. As a rule, to the control of instruction in which there is a table codes for different models of air conditioners. To configure the remote control there are two modes - automatic and manual mode.

Auto mode you can use if you don't know what you have air conditioning or a code table is not your model. To configure auto search, you must have the remote control in hand, and directed to the conditioning. Look on the remote "SELECT"button,press and hold for 5 seconds, then release.

The remote will automatically send commands to the air conditioner and cycle through the available codes. In this case, the display shows the codes that are flashing and changing. As soon as the correct code you will hear a beep from your device and air conditioning turns on. At this point you should press any button on the remote, scanning codes will be stopped.

Check the operation of the air conditioner with this code. If the commands are not performed correctly, or some functions do not work, run the auto search codes again until you find the code under which your air conditioner will work correctly.

Setting in manual mode takes less time. Find the code in the code chart for your model of conditioning, there may be several. Click the "SELECT" button, and the code the display should blink once. Using the numeric buttons to enter the code in the memory of the remote control and press the "ENTER" button, the remote is programmed.

Check out how commands are executed by the air conditioner. If you don't correct the air conditioning system, try to enter turns the other codes. Also cycle through the codes using the buttons "TEMP" and "TEMP-".

After entering the correct code, the remote control air-conditioning ready to operate. You will have access to all basic functions. With the remote you can select the operation mode of the air conditioner is cooling, heating, ventilation, auto mode. You can set the desired temperature, adjust the fan speed and choose the direction of air flow.