You will need
  • Remote control.
Instruction
1
Turn on the TV. Press info-menu-mute-power. This combination is suitable for most PDP and LCD TVs. But some models, especially with a diagonal of 23 inch do not respond to this sequence. They have laid another combination - MUTE-1-8-2-POWER ON. It should be noted that all these keys to be pressed sequentially and as quickly as possible (no more than 1-2 seconds to do this). If you fail the first time, try again. You see a window with the heading “Service Menu”.
2
Navigate through the menu using the control buttons (right, left, down, up). In order to select a specific section – click “OK”. To exit to the upper level press “Menu”.
Structure engineering menu changes every year, there are new platforms and firmware, but does not change the basic parameters:
- Panel On Time – the first line stands for “life panels”.

- Ready – turn on and off with the DTV tuner ON and OFF, respectively).

- Option table – not depend on the input and is responsible for General settings of the TV.

- Shop Mode shop mode (ON / off, OFF – on).

- Dimm Type – information about the matrix that is installed on your model.

- Reset – reset.
3
Make adjustments to the settings. Before doing so, think whether. Incorrectly changing a parameter can be completely knock down all the settings after wizard you will not understand.
4
Save the settings. If you wish to restore the default (factory) settings, run the command “Reset”.
5
Turn off the TV to exit the engineering menu.
6
If, after adjustments have deteriorated the image or you have any other problems, go back to the menu and load the standard settings (Reset).