How to fill a manual typewriter

Manual sewing machines are still very popular. This is natural: some old machines are capable of sewing such fabrics that are "too tough" more sensitive and less universal to modern cars. But manual typewriters has its own peculiarities that must be taken into account. And above all you must learn to fill it.

You will need

• Sewing machine
• The spool of thread
• Shuttle
• Spool

Instruction

1. Prepare the spool. It is better to wind it threads right away, so as not to be distracted. Winding thread manually or by using the same machine, insert the spool in the Shuttle so that the thread direction coincided with the direction of the slot. The Shuttle to the Shuttle device can be inserted directly, in order not to get lost and not interfere.
2. Put the coil on the top pin. On some old cars the two pins on the machine body, so you need one that is closer to the flywheel. Unwind the end of the thread 20 centimeters Lift the presser foot of the machine and place it in the top position.
3. Guide the thread from the coil into the upper thread guide is such a small recess in the wall of the machine, which is on your left. It is round or triangular in shape with a slot. Enter the thread in the regulator tension of the top thread — a special device on the same side of the machine, consisting of several metal washers. Guide the thread between the washers. The regulator you need to go around the bottom. From the other side of the regulator, which is closer to you, you will see a hook that is called nettabrielle. Start the thread.
4. Guide the thread into the spring, which is located on the back wall closer to you. Modelah on some cars this spring, and then guide the thread from the hole of sitepreferences.
5. Start the thread in the lower thread guide. On a more or less modern machines such thread guide can be two, very old — maybe only a little hook on the needle clamp. Get back to the thread, then pass it into the eye of a needle from the groove.
6. Pull the bobbin thread exactly the same as any other machine — lifting his foot and lowering the needle holder with the needle down. Adjust the tension on the upper and lower thread. It is recommended to take any scrap and try to sew in different modes, turning the regulator screw of the tension of the upper thread and changing the stitch length with the help of a special foot, which is located on the side panel.