How to construct the skirt pattern pencil

Straight skirt is knee length, narrowed downward, is always in fashion. Very often the individual characteristics of the figure, make the purchase of this skirt in the store is problematic. To tailor a skirt - pencil yourself by your standards is not difficult. For the calculation you need to measure: poluobhvat waist (ST), poluobhvat hips (SB), length of skirt (DU) and length to waist backless (ДТС2). How to take correct measurements you can find in any magazine on sewing.

You will need

• - a piece of tracing paper (Wallpaper or wrapping paper)
• calculator
• pencil
• - line
• - cm tape.

Instruction

1. Draw a rectangle with vertices T, T1, H, H1. Side ТТ1 should be leveled SB+1.5 cm, side T – length skirt. To find the hips divide the amount ДТС2 by 2 and subtract 2 cm. the Resulting value of the move from point T down and draw a horizontal line placing points B and B1. Divide the amount of SB 2 and the resulting figure aside from the points T, B, N to the right, putting the point T2, B2, H2. Connect the resulting points with a vertical line. The resulting rectangle will serve as the basis for the rear cloth skirts.
   
2. To determine the total solution of the recesses, from poluobhvat hips SB+1.5 cm subtract poluobhvat waist, ST+1, see the Resulting value (SV) is required to write. For the design of the lateral line skirt SV, divide by 2. The resulting figure is 1/2 aside from the point T2. Swipe diagonal line 2 cm above the point B2. Gently smooth the line under the bulge of the thigh approximately 1 cm upwards. Aside from the point N2 to 3 cm in both directions and place saugeye skirt down, not bringing it to the leg about 10 cm is left for You to draw rear and front undercut.
   
3. Cut ББ3 multiply by 0.4. The resulting magnitude of the move from point B and extend up to the waist line, put a point T3. Solution back undercut is 1/3 of the total recess (SV). Put the value of the point T3 in both directions. Draw a diagonal line up to 2cm above the point B3.
4. Determine the position of a front undercut by multiplying the segment length Т2Т1 0.4.The resulting value is put from the point B1 and extend up to the line ТТ1, put a point T4. The front undercut width is 1/6 of the SV. Let's pack the correct number in both directions from the point T4. The length of the undercut 10-12 cm Side draw in a straight line. In the final drawing, the angle of thigh lift by 1.5-2cm and smoothly complete your waistline. Draw the basic lines and cut out the finished pattern.