You will need
  • magnet
  • glue "Moment universal"
  • - sandpaper or nail file (grit 80)
  • - double sided tape
  • - alcohol, acetone or solvent
  • - cotton
Instruction
1
Carefully prepare the surface to which it is necessary to glue the magnet. If it's plaster (stucco), remove all burrs and protruding indent. Do this with fine sandpaper (emery paper) or nail files for artificial nails (grit 80). Move in one direction only – when driving back the plaster may crack. When the magnet is required to stick to the wood or plastic, clean the surface. Apply a small amount of alcohol / acetone / thinner on a cotton pad and wipe them with the necessary place. Allow to dry yourself. Do the same thing with a magnet (if you glue it on the glue).
2
When the magnet is required to stick to the wood or plastic, clean the surface. Apply a small amount of alcohol / acetone / thinner on a cotton pad and wipe them with the necessary place. Allow to dry yourself. Do the same thing with a magnet (if you glue it on the glue).
3
To stick self-adhesive magnet, cut a piece the required length. Remember that in this type of bonding, the product must be very easy. For example, a small magnet on the fridge or a photograph. Remove the protective film from the magnetic strip, then press it into prepared on the product site. Hold it for a few seconds.
4
Thin magnetic tape is also designed for bonding to a light flat products. It has no adhesive layer, so depending on needs you can use either double sided tape or glue. If you chose the glue, apply a thin stripe with a wavy line from the beginning to the end of the magnet. Do not apply directly to the product, hold the air for 10-15 seconds. Strongly press in to the prepared place. Wait another 20-30 seconds. Do not use the product immediately, it is better the next day.
5
For heavy items made of wood or plastic using conventional magnets. They can be different thicknesses and shapes. To glue such a magnet, clean the surface from dust, grease and dirt. Apply a DAB of glue both on the surface of the magnet. If you just allocated a place on the product, you can put some glue on it.
6
Do not apply immediately, allow the glue a bit to get to grips with the surface for 15 seconds. Attach the magnet to the product, strongly press. Hold as 30 seconds. If the product is not fragile, then put on top of the day something heavy for best results fixing. After a time carefully lift the press, check the firmness of the magnet.