How to install wall panels PVC

Wall cladding panels PVC is one of the most popular solutions because it allows you to quickly and inexpensively decorate the walls of any quality of its own. Even if you never were engaged in repair, install wall panel PVC will not make for you work.

You will need

• - PVC wall panels;
• - drill;
• - plumb
• - screwdriver;
• - gon;
• - hacksaw for metal and wood;
• - scissors;
• - hammer;
• pencil;
• roulette;
• stepladder;
• glue;
• - screws;
• - nails.

Instruction

1. If you are doing repairs in the winter, leave the bar, entered from the street, in a warm room for a day or two. Please note, the installation of the panels is recommended in a warm room at temperatures not less than +10°C.
2. Rate the condition of their walls, if they are smooth, you can just glue panel. Prepare the surface for bonding: wipe clean from dirt and dust, degrease, zashpaklyuyte cracks and holes. Then apply primer with a brush or roller. Smooth surfaces, such as enamel or lacquer, scuff with sandpaper, clean, wash, degrease.
3. Evenly apply the glue and let it soak in a little into the wall and the panel (a few minutes). Attach the panel to the wall, press and smooth top down and from the center to the edge. When the glue a little clutch, attach the next panel, overlapping or joint to joint, depending on the manufacturer's recommendations.
4. If the wall is not perfectly smooth, before starting work, install the sheathing, it may consist of wooden slats or steel profiles. Place Reiki is strictly perpendicular to the panels, between them must be at least 60 cm To the wall attach the slats with screws or dowels.
5. For winterization, close the wall with sheets of heat insulation material is laid by placing them between the slats, they will give the wall greater heat and sound insulation. Apply on the side without a foil layer of glue and attach to the wall. The joints seal with aluminum tape.
6. Complete installation of PVC panels on the wall. Start by installing internal and external corners profiles ceiling and floor. Take the bar from the corner of the room, securing them with staples, screws or nails. Try to place the fasteners symmetrically.
7. In the room with high humidity such as a bathroom or shower room, make the strips small cuts to improve air circulation and keep the coverage for a long time.