You will need
- - serpyanka;
- - scissors;
- knife;
- - putty;
- - glue (Bustilat, PVA, acrylate, etc.);
- - spatula;
- - sandpaper;
- - primer.
Instruction
1
Prepare the surface to reinforcement, thoroughly clean it of dirt and dust, degrease, remove stains and irregularities. If necessary, scuff and remove the old coating (old paint, Wallpaper, etc.) mechanically. If the surface is smooth, programsuite it to improve seizure.
2
Fill fill or leveling compounds (glue, plaster, cement) cracks, pores, joints, corners or other imperfections, which is subject to seal the junctions. Let dry and scuff when dry.
3
Apply a spot of sealing adhesive layer (Bustilat, PVA, acrylate, etc.) or liquid putty with a brush or roller.
4
Cut a piece of serpyanka the required size and glue it to the treated area. Smooth the material with a spatula or a large brush-maklovitsej.
5
For more reliable setting soak serpyanku in diluted glue (8 or 9 parts of glue, the rest water).
6
For sealing joints in plasterboard attach serpyanku without glue. To do this, dissolve the putty until thick sour cream without lumps is obtained and apply it to the seam. Then gently apply the cut tape serpyanka to the seam and press it into a layer below it is completely soaked. Please note, do not hang thus a large surface, the putty will not be able to provide sufficient reliability.
7
After the junctions will take its place and dry, completely fill the surface. Collect on the spatula a small amount of material and apply it glides on the seam without applying much effort. Hold the trowel so that the angle between the inner plane of the spatula and the surface was sharp, the mixture was applied evenly and not pressed into the seam.
8
Let dry for time specified on the package with putty, scuff. The resulting bulge on the surface remove the next day with sandpaper. Apply primer and surface – paint, glue Wallpaper, etc.