How to paint the body of the phone

Pick a room to paint the caseand phone. The room should be well ventilated and reasonably clean, as dust particles can damage the result. Prepare the surface for painting. Cover it with the smooth material. You can use a dense white oilcloth.

Read the instructions to the phone on its technical side. Prepare in advance the necessary screwdriver set. Dismantle the phone to details. If you don't want to disassemble the phone or you don't have the right tools, you can use masking tape which stick everywhere should not get the paint, namely the keyboard, screen, connectors, etc.

Prepare the surface of the bodyand for painting. Mix a thin putty and hardener and zashpaklyuyte deep scratches on the bodye phone. Clean the surface by means of fine sandpaper or a special block. After the plaster dries, rinse the parts of the bodyand from dirt and dry. Apply to the surface of the phone special primer for plastic. Leave the device to dry for a day.

Check that the phone is dry, treat it with sandpaper. As a result, should get a completely smooth surface. Take a hair dryer and blow out the case from dust. Clean it from oily swelling and fingerprints.

Spray paint on the surface of the housingand holding the spray at a distance of 30 cm from the surface. This will ensure an even coat and no drips. Allow paint to dry for 20 minutes and apply a second coat. Then after 20 minutes, cover the hull with two layers of lacquer, allowing 15 minutes drying. Apply on phone the pattern using brushes and watercolors, and then cover the hull again with two layers of varnish with an interval of 5 minutes. Allow to dry and assemble the parts of the phone.