Before you start knitting a tourniquet beaded beaded and ornamented, it is necessary to learn the basics of creating wire harnesses and such to practice on the larger beads.
You need to understand what air loop, Poustovit and column without nakida. Other special knowledge to create crochet beaded harness is not required.


The set of beads on a thread



The first stage of creating knitted wire harnesses is a set of beads on a thread. This stage sometimes takes more time than actually knitting.

Select the beads can be any size and shape. Even uneven beads will look good, but really high-quality beads will improve the decoration. If you want to make harness ornament, you need to choose one of the many schemes set which provide the desired result. Scheme you need to follow exactly, otherwise the pattern will turn out correctly. However, by using alternating beads of different sizes, crocheted harness will look like relief or even bend the waves.

When the collection of beads remember, cut the thread from the ball in any case impossible. All you need to gain about 1-3 meters of beads to make a bracelet or a necklace. Length of set depends on the size of the bead is smaller than it, the more it will need. Thread for knitting you need to take the average thickness, preferably a thin iris without lurex. Hook size – 1 – 1.5 mm. Dial the beads you need with the help of a needle. Thread in the needle thin thread, tie it around the main yarn for knitting, and then collect the beads, moving it from the needle thin thread to thick towards the ball.

How to knit the first rows



The second stage crochet harness from typed on thread beads.

The first row consists of loops, each of which engage the bead. The number of beads in each row depends on the thickness of the harness. The classic harness is usually knit from 6 beads in diameter. Making an aerial loop, you must capture the bead, pushing it closer to the hook.

The second row will consist of the same number of beads in the first row, each of them must be strictly above the bead of the first row. Without removing the last loop of the first row from the hook, enter it in the first loop of the first row, move the bead to the right of the hook, slide a new bead on the thread to the loop. Grab hook new bead and enter the thread through the loop bead of the first row and loop that was originally on the hook. Is knitting the column without nakida, which is suitable for narrow bundles of beads. Column to knit the larger the diameter of the bundles.

How to finish knitting harness beaded



The third and subsequent rows are knitted the same. The main difficulty at the beginning – don't mix up the hinges and not to bring two beads on one or skip some of the loops of the previous row. Carefully consider how many beads in each row, watch. To match. After the 5-6th rows knit beaded harness is easier to get lost is almost impossible. Knit in a circle. Until you get the desired result.
If you want the beads came to an end too early, you can continue wiring. To do this, enter another bead, and then tie the remaining tip of the threads and the tip of the new so that the node is located inside the harness.


To finish the harness of bead simple: tie a knot at the end, clip inside the harness behind its walls ring pin, slide the metal cap, bend into a ring, the second end of the pin and attach padlock. The same make with the second end of the harness.