You will need
- Speakers, metallic fine mesh, glue, tool set, scissors, acrylic, organic glass, compass, pencil, sandpaper, a fan, a box of disk.
First disassemble the design of columns.
Make acoustic wire disconnected from the Board using the connectors.
Use templates with which you will be able to cut parts from acrylic. To do this, apply the compasses and pen to future housing had right angles.
The finished wall is undercut.
Undercut organic glass with sandpaper.
Cut a hole for the speaker.
If you decided to work with the fan, and you need the mesh, cut to fit the wall of the housing, as well as screws. Secure the mesh with screws.
For the manufacture of the grille on the fan, use a box from a disk. Cut out its contours and undercut sandpaper.
Cut two grilles for the speakers on the front wall speakers. For this you will need a box from a disk.
Connect with glue, mesh and grid to create a front panel housing.
At the base should make holes for the wires and LEDs (4 pieces).
Glue all parts to the caseand are kindly requested to return all the internal contents of the columns.
Be careful when working with glass and creating patterns. Better prepare a compass and writing materials to all the edges of the future of the housing were smooth.
To get great sound out of the speakers, you need a good case. You can use the sieve as mesh for the front panel.