You will need
  • - plasterboard;
  • - wooden slats;
  • - dupes and screws;
  • - drill;
  • - hacksaw;
  • - screwdriver;
  • - putty;
  • - spatula.
Instruction
1
Before how to strengthen the drywall to the wooden wall, buy supplies. The leaves are kept on the wall on the screws, screwed into a wooden or metal frame.
2
If a wooden wall is smooth and does not require alignment, you can mount the drywall directly to it, but is extremely rare. In most cases, to achieve a common plane and the clear corners is possible only through the rack frame, the thickness of which is adjusted by the method of putting a strip of additional pieces of rail. Such method of installation floor area is reduced slightly.
3
Secure the slats with a thickness of 20-25 mm on the wall using duplay, the distance between which shall not exceed the meter. This thickness is taken in the case when the drywall is mounted without an additional layer of insulation and soundproofing material between the sheets and the wall. When using such material the thickness of the strips depends on it.
4
Support bars are mounted horizontally, first from floor, second from the ceiling. The number of the rest of the slats depends on the height of the room, but to achieve the normal density of attachment between them should be no more than 50 cm.
5
Having measured the correct size, cut the desired part of the sheet of drywall. You can cut it with a hacksaw, but it is much easier to make two parallel cuts with a sharp knife on both sides of the leaf, then easily reverse the sheet in place of the cuts.
6
Attach the plasterboard to the battens with screws, screwed every 25 cm Leaves are placed close to each other. After fixing the seams and holes in which to stick the cap screws, zashpatlevyvajut. To impart greater smoothness to the walls to complete the installation of drywall you can, inflicting putty on the entire surface of the leaves.