When entering the cell of the second call, the phone beeps, which tells about an additional incoming call. Most often it is beeping. At this time, the caller hears the phone ringing on the other end until, until the subscriber can answer the second line. The subscriber in this case has the opportunity to either answer the new call, or continue the conversation on the first call, leaving the other on hold, or completely disable the new call back to this number later.
To answer the incoming call without interrupting the call, press your phone's "Hold", and then press the call button. The system will switch you with the first caller, who at this moment is to hear the music signal, on the second, with which you can start communicating.
If the current conversation is very important to refrain from making 2 calls by pressing the "reset" button. Then the caller on the other line hear a busy signal.
If you need to have a conversation on the other line, put the current call on line 1 with active link status on hold call and answer the second call, which will be set to the active state automatically.
You can end the call on the first line and press end a call. In this case a call on the second line also will automatically switch to the connection state.
In different models of phones to switch to the second line : selection with the arrow keys between the two input numbers needed, by pressing certain keys responsible for the call transfer in active or inactive state. Correctly switch between incoming calls, read the instructions that came with the phone.
In addition, there is further connected a function of the conference connection. You will be connected with two subscribers that will hear the person they called, and each other. This option is very useful when implementing some business calls, conversations with friends. To connect, contact your service provider.
Advice 2 : How to turn Nokia into standby mode
Mobile phone from any manufacturer, including Nokia, if included, may be in a mode of conversation or expectations. To put it in standby mode, you need to simply enable or terminate all current calls. In most models, Nokia key when switching to standby, press end.
Press and hold (second from top on the right side of the keyboard, with a red handset) lights out, lights up the display when your phone is turned off. If the unit is weak or dead, no reaction to this action will not follow. If battery is discharged, you will need to connect the phone to the wall socket and wait a bit until you accumulate at least a little electricity, and then retry the operation. If the phone is faulty, give it in for repair.
If the reason for disabling your phone was full battery drain and the device is charging, the screen can appear only indicator showing that the phone is charging. Press the hang up again, hold for a few seconds until the indicator disappears. Then click again and hold until the display lights up.
Enter the pin code at the request of the device and press the confirm key select the upper left. If the pin is correct, the screen will display a message that the code is accepted, then the Nokia splash screen, then the phone will turn on and operate in the standby mode. If you refused to protect the pin or it was never installed, the phone will turn on immediately.
Complete all challenges to move from the talk mode to the standby mode. To do this, press release, marked with a red tube and located at the upper right of the keyboard. If you have several calls complete not only the current, but all held press release. After that the phone will go into standby mode, and you will be able to accept the challenge, if someone will dial your number, call the desired subscriber, or use additional options: to send or receive SMS (to their phone will be in talk mode), use the built-in radio, take a photo or video, use the organizer, phone book, various applications, games, etc.