You will need
  • glue;
  • - Bicycle pump;
  • rubber;
  • - welding machine;
  • - grinder (angle grinder);
  • - tube Bender;
  • pipe;
  • - fiberglass;
  • - epoxy adhesive;
  • - engine oil
  • - new detail.
The most common problem is a deflated or punctured the wheels of the stroller. Remove the damaged wheel by pressing the lever in the center. With the help of the Bicycle pump pump up the wheel, Krutov tip (the hole is located on the inside of the rim).
The punctured wheel seal. To do this, remove the wheel and tire, then remove the camera. Inspect it for any punctures, pouting, and spread the soap suds – the place where they will inflate the bubbles, check the marker.
Cut from a piece of rubber (e.g. old tyres) round the patch. Thoroughly wash and degrease the surface, apply the glue and leave for 30 minutes. Then heat them and attach the patch to the tire, and firmly press. A day collect the wheel and test.
If you could not inflate the wheel or stick, take them and take to the tire. For a small fee you will carry out all work quickly and efficiently.
Try to adequately assess damage and your ability to repair. Damage in the "joint" adjustable handle or other automatic node fix only specialist, so order part in a specialized repair center and replace.
If broken, the metal part of the stroller, try her brew. Bended metal parts easier to make yourself. Pick up a tube of suitable diameter, cut a piece the right size grinder, when you fold the tool. Note the symmetry of the parts on the finished wheelchair.
Plastic part try this: remove the integer part of the wheelchair (symmetrical on the other side). In addition, as a model, you can use a item of foam, cut to the broken sample.
Cover the model surface with engine oil, place a layer of fiberglass. Promazhte epoxy glue, again lay the fiberglass. So take a few layers. After complete drying, clear detail with model paint and better spray gun.
If the item is attached to the carriage by rivets, it is best used for its fastening riveter (sold at any hardware store). Either drill through the part and secure it with the bolts with decorative caps.