You will need
  • Fine wool or cotton yarn, hook, scissors.
Instruction
1
Cap is designed for the circumference of your head, 35-37 cm loops tie a chain length of approximately 30 cm continue Knitting columns with nakida. Link the rectangle with a height of 10-11 cm Thread tear off.
2
Promazyvanie the back of the cap.

Fold the resulting rectangle in half. Both sides of the middle measure 4.5 cm and mark these points contrasting thread or with pins.

The first row of the rear of provarite columns with nakida. In 2-4 rows on two sides make the addition of one column with nakida. Vymazyvaja additional columns from the base of the far post. 5 a number provarite without additions. The width of the fabric should be 9-10 cm Then every odd row, do subtraction from both sides on one bar. Line the side of the cap and back should be the same length.
3
Align the edge of the side and back of the cap. Connect them to the bars without nakida. Hook spend immediately in both parts of the cap. Should be a seam in the form of braids. The seam on the cap should go on the outside.
4
The thread is not cut. Provarite fold beanie columns without nakida and perform a second stitch in the manner described above. The thread should be at the bottom of the cap.

Get the base hats. You can leave the cap as is, tied with a drawstring. But that cap turned out elegant and beautiful need to decorate.
5
The seam of the braid for decoration provarite openwork lace. So lace was a beautiful shape, the edge can be tie Pico or "crayfish" step. The cap according to your wish you can decorate with ribbons, bows, embroidery.
6
To give the cap a beautiful shape, it can be tied columns with nakida in a circle, pulling the thread a little or promazyvaya together every 4th and 5th column.
7
To make drawstring, dial from the edge of the bonnet air loops chain the desired length. Tie one row of polostevichi – tie ready. In the same way the second link. The knots on the drawstring tighten, thread, cut and fill. Cap amperite iron. The product is ready.