However, the permanent contact with technology requires us to some new knowledge. That is, if you want to use technology, be prepared for the fact that you will need to learn how to do the basic repairs of their machines. The problem faced very often, it is a violation of the microphones in phones, headsets and microphones to computers. Note that to fix the microphone as a rule, not difficult, repair is elementary. However, most often we lose time, money and nerves to carry the microphone in the Studio.




There are three common problems that put the microphone down. If we consider the problem carefully, it can be solved independently.



  1. The microphone loses sensitivity because of clogging. Dust, microparticles of the skin, the COP gets on zvukousilitel head and that loses its properties. To fix the microphone in this case, need wool alcohol and a screwdriver. You need to release the microphone. To do this, sometimes you need to spin the phone or remove the cover with it. Then dip the cotton wool in alcohol and very carefully remove the plaque from the head. Keep the wool left on it. Let the alcohol evaporate and set the microphone back.

  2. The microphone loses sensitivity due to moisture. Sometimes between the gasket and the head is delayed condensation. Usually, the head does not rust, but the moisture does the job. You need again to release the head and to warm it under a lamp. If there are pads, the same should do and take off.

  3. The microphone fails due to rupture of the incoming wire. There are two options – change, or soldering. To apply them you need based on the specific situation. Phones, often need to solder the broken wire. With headphones, there are situations of violation of the wire in multiple places, then it's better to change everything.


If the problem is serious change the whole unit, especially when it comes to the phone. As for the set, then it is better to just replace it completely.